RS2DMX-G2 RS232 to DMX Interface
This unit is the 3rd iteration of our best selling range of RS232 to DMX converters. This updated version features our built in fade engine allowing even the simplest controllers to trigger smooth crossfades.
Built in Preset storage allows the creation of 8 scenes with the ability to crossfade between recalled scenes for the ultimate in professional transitions.
An robust internal power supply allows any 9-30v DC power supply to be used.
A simple 3 wire serial interface with easy to use and fully documented protocol allows the unit to be driven by everything from simple one way AV control systems right up to high end control and PC based systems.
Serial to DMX interface box
Model RS2DMG-G2
Connectors
Serial Input:
9 pin female DB9 connector
DMX Ouput:
5 pin Female XLR connector
Power
Powered via 2 pin Pheonix 5.08mm terminal (Supplied)
Power is 9-30v DC
Indicators
Power : Red LED
Serial Data: Yellow LED
DMX Data :Green LED
Dimensions
Width: 92mm (3.7”)
Length (excluding connectors): 148mm (5.8”)
Height: 38mm (1.5”)
Weight
225g (0.5 lbs)
[/vc_tab][vc_tab title=”Downloads” tab_id=”1388810098-2-63″][vc_column_text]
Data Sheet
bluecog rs232 to dmx info G2 2014
Serial Protocol
RS232 DMX box 2G protocol 0714
Frequently Asked Questions
> What power does the box require ?
> What do the LEDs show ?
> What are the Serial port specifications ?
> Can I update the unit to a newer version ?
> Do you publish the serial protocol ?
What power does the box require ?
The box accepts a DC power input of between 9v and 30v DC. The unit is protected against reverse polarity wiring. We recommend only a regulated DC supply is used.
What do the LEDs show ?
The LEDs show (from left to Right) DC Power (Red), RS232 Data Received (Orange), and DMX Output Enabled (Green).
The RS232 led will flash briefly on data reception on transmission. The DMX LED will illuminate to show DMX data is being transmitted. It is actually blinking at the Transmitted DMX rate which is around 20Hz which will look like its always on – but if you move your head while looking past the unit you will see the high frequency flickering as a trail of LED flashes.
What are the Serial port specifications ?
The serial port is a 3 wire connection with only pins 2, 3 and 5 used. The unit uses 9600 baud and requires all commands to have a CR line delimiter. Earlier versions required a CR-LF delimiter, but this requirement has been removed in later firmware. If you do send CR/LF it will not cause any issues, we still offer it for legacy support.
Can I update the unit to a newer version ?
Te unit has a bootloader which allows the firmware to be updated using a small PC application. As new features are added or pesky bugs are squashed there may be new firmware versions made available. Signup for Firmware Update notifications here to make sure you always have the latest version.
Do you publish the serial protocol ?
Sure Do. You can either get it from the Downloads Tab above or click here – RS232 DMX box 2G protocol 0714